Canton VRA 3 Bedienungsanleitung Seite 83

Max Volume [VOL]
You can limit the maximum settable volume with this (protective) function Max Volume in such a way that the sound level (indicated in the speaker's display)
cannot be turned up above the set value. You can set the desired volume level from 0 to 70, where 70 represented the maximum.
To change the maximum volume, do the following:
To enter the Menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the menu item and then item Max Volume and confirm with the "OK" button.
3
Press "OK" and change the volume level using the "+" or "-" key. Then press "OK", again.
4
Note: This function does not limit the output volume level of the speaker to a certain level but only the selectable volume. Based on the incoming signal
(level) the output volume can be higher or lower.
Dynamic Range Control [DRC]
Dynamic Range Control (DRC) is a setting option created by Dolby Laboratories. When activated, the dynamic range of encoded data
streams can be automatically reduced, which also reduces differences in volume. This makes it possible to enhance quiet tones and
suppress loud ones.
To change the setting, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
2
Select the function Dynamic Range Control [DRC] and confirm with the "OK" button.
3
Select the wanted value using the "+" or "-" key.
4
[ON] means the DRC function is activated and the dynamic range is controlled by the meta data of the data stream.
[OFF] means the function is deactivated and the dynamic range will not be controlled.
Press the "M" button to exit this menu item.
5
English
3 8 3