Weidmuller MCP Plus 2 Bedienungsanleitung Seite 28

Commissioning
5.5 Loading the plotter
We recommend preparing the mounting
plates off the plotter and placing them in
the plotter before the plotter is switched
on. This allows you to be certain that the
auto-calibration process is effective, even
when the writing arm is moved during the
loading process.
► Fit the adjustment plate into the mounting plate as
shown in the software (specification position 1 to
5, position 6 means no adjustment plate).
1
2
3
4
5
6= without this inlay
Fig. 5.2 Positioning the adjustment plate (here: position 3)
► Place the labelling elements on the adjustment
plate.
► Place the fully loaded mounting plate flush to the
left on the base plate of the plotter so it is held by
the holding pins.
28
4326440000/04/12.2016