Weidmuller MCP Plus 2 Bedienungsanleitung Seite 21

2 Safety
2.1 Intended use
The plotter MCP Plus 2 is designed for the labelling of
markers or labels fitted to industrial systems. The op-
eration of the plotter is controlled by the M-Print
software. It is designed for commercial environments
(offices).
The device is only designed for the application
described in the user manual with the labelling
elements described.
The device must not be opened. Repairs, including
replacing the power pack, must be carried out by a
qualified electrician.
Observance of the documentation is also
part of the intended use.
2.2 Labelling elements
The following materials can be labelled with the
MCP Plus 2:
– Markers in MultiCard format
– Labels
2.3 Electrical connection
The device can be operated in the 100–240 V AC /
50–60 Hz voltage ranges. The electrical connection
conditions must correspond to the information on the
type plate.
2.4 Operating personnel
These operating instructions have been written for
trained and qualified personnel who are familiar with
the valid regulations and standards applicable to the
field of application.
2.5 Conformity
The product complies with the following European
directives:
– Low Voltage Directive 2014/35/EU
– EMC Directive 2014/30/EU
4326440000/04/12.2016
2.6 Disposal/Recycling
At the end of its service life, make sure the device is
disposed of in accordance with the local regulations.
PRO
®
You can also return the device to Weidmüller for
proper disposal. Simply send it by parcel service (in
a box) to the Weidmüller subsidiary that supports
you. We will then take care of all of the recycling and
disposal activities.
21