Werbung
12
CMS 801 Series
Mechanical Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a fl at surface. Mark the cut-out area
on the ceiling tile by tracing around the template provided.
2. Cut out the hole in the ceiling tile using a circular saw or pad saw.
3. Place the C-ring and tile-bridge on top of the ceiling panel, aligning the C-ring over the hole,
and screw the C-ring to the tile bridge using the fi xings provided.
4. Slide the speaker assembly through the hole and turn the screws on the front of the speaker to
extend the mounting wings. Tighten the screws until a fi rm grip is achieved.
If using a power driver, TANNOY recommends a torque setting of 1.5 Nm.
DO NOT OVERTIGHTEN!
5. Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over the
railings, supporting the weight of the speaker.
Go to the 'Wiring and Setting Up' section for instructions on wiring and set-up instructions.
Mechanical Installation Guide for SheetRock (Plasterboard) Ceilings
1. Mark the cut-out area on the ceiling by tracing around the template provided.
2. Cut out the hole in the ceiling using a circular saw or pad saw, then slide the C-ring into the
ceiling, aligning it over the cut-out hole).
3. Go to the 'Wiring and Setting Up' section for wiring and set-up instructions then return to
point 4 below.
4. Slide the speaker assembly through the hole and turn the screws to extend the
mounting wings. Tighten the screws until a fi rm grip is achieved.
If using a power driver, TANNOY recommends a torque setting of 1.5 Nm.
DO NOT OVERTIGHTEN!
5. Insert grille by pushing it onto the speaker.
Quick Start Guide
13
Werbung
