Kinderkraft LOVI Bedienungsanleitung Seite 18

1. Baby cot elements (FIG. 1):
A. Baby cot frame with carrycot
B. Mattress
C. Canopy with mosquito net
D. Runners for rocking x2
E. Metal tubes x4
F. Toys x2
G. Bag
2. Baby cot assembly:
Undo the zip fastener on the bag (G) and remove the cot and other included items. Connect the
runners (D) with the metal tubes (E) until the metal pins click (FIG. 2). To disassemble the frame
(A), lift the ends of the frame until the mechanism locks (FIG. 3). Place the carrycot on a clean
surface with the metal tubes facing upwards (FIG. 4). Then push the runners onto the metal
carrycot tubes until they lock (FIG. 5A). Note: The arrow at the bottom of the runners should be
visible outside the cot (FIG. 5B). Attach the material on both sides of the carrycot by properly
pressing the latches (FIG. 6). Place the mattress (B) so that the usable area was directed upwards
(marking is located on a label attached to the mattress cover). Note: The baby cot has a rocking
function − hold the release button located on the outside of the rocker and change its location
as shown in Figure 7. To return to the standard cot position, press the button again and place
the runner in the starting position.
3. Installation of accessories:
Canopy − attach the canopy (C) by placing the plastic element in the rail located on the carrycot
frame (FIG. 8A). Make sure that you hear a click during installation (FIG. 8B). Attach the canopy
material to the Velcro located on the carrycot cover (FIG. 9).
Toys − the upper part of the canopy features loops for attaching the included toys (F) (FIG. 10).
Mosquito net − undo the zip fastener located on the canopy, remove the mosquito net and
place it on the carrycot frame (FIG. 11A and 11B).
4. Folding the baby cot:
To fold the product, place the runners in the starting position (standing). Remove the canopy
by pressing the button and pulling the plastic piece out of the rail. Press both buttons in the
centre of the frame, while slightly raising the cot (FIG. 12). Tilt the carrycot towards yourself and
the legs will fold automatically. Slightly press the mattress against the folding legs (FIG. 13).
Attach the Velcros located underneath the carrycot by pressing both parts of the baby cot as
shown in Figure 14.
5. Maintenance and cleaning
Fabric on the baby cot and canopy − clean with mild soap and water. Never clean using abrasive
cleaners on the basis of ammonia, bleaching agents and spirits. The baby cot must be dried
thoroughly before using or storing.
Bottom of the cot − clean with mild soap and water. Never clean using abrasive cleaners on the
basis of ammonia, bleaching agents and spirits. Do not wet the base plate and before re-use
make sure that all parts of the baby cot are dried thoroughly.
Sheet − wash at max. 30°C, standard process, do not bleach, do not tumble dry, iron or dry
18