TEUFELBERGER fImblSAVER Herstellerinformation Und Gebrauchsanleitung Seite 8

rEGUlar CHECKS
Therefore, store the product dry and ventilated in
a moisture-repellent bag that is impervious to light.
For cleaning, use lukewarm water and – if available
– a rope detergent in accordance with the cleaning
instructions provided thereon. Do not use a textile
detergent. Following cleaning, rinse the product with
plenty of clear water. In any event, prior to storage
or use, allow the product to dry completely in a
natural way and not in direct sunlight, or near fires
or other heat sources.
For disinfection, use only such substances that
do not have an impact on the synthetic materials
used. Do not disinfect the product more often than
is absolutely necessary! We recommend the use
of isopropyl alcohol 70%. Apply the disinfectant
to the surface for about 3 minutes and allow the
product to dry naturally. Be sure to observe the
safety instructions for the use of the disinfectant.
If you fail to observe these provisions, you will be
putting yourself into danger!
Product inspection record sheet:
Manufacturer:
TEUFELBERGER
Fiber Rope GmbH,
Vogelweiderstraße 50,
A-4600 Wels
Batch No.:
Date of Production:
Compatible components within harness based work at height systems:
Comments:
8
Model:
Serial No.:
Purchase Date:
7. REGULAR CHECKS
Checking the equipment at regular intervals is ab-
solutely necessary: your safety depends on the
effectiveness and durability of the equipment!
Following each use, the product should be checked
for abrasion and cuts. Also check it for the legibility
of the product labelling! The use of damaged com-
ponents or components subjected to a fall must be
discontinued at once. If there is only the slightest
doubt, the product needs to be retired or subjected
to testing and by a competent person.
When using the equipment in occupational health and
safety to EN 365, it must be checked at least every 12
months by a duly qualified person strictly observing
the instructions, or else by the manufacturer, and
it must, whenever necessary, be replaced. These
inspections must be documented (documentation
of equipment; cf. the following table). It is advisa-
ble to mark the anchor divice with either the next
or the latest date of inspection. Refer to national
regulations for inspection intervals.
Retailer:
Name of User:
Date of First Use: Date of Retirement: