TEUFELBERGER fImblSAVER Herstellerinformation Und Gebrauchsanleitung Seite 7

top of the friction hitch and affect or eliminate the
reliable grab function. Modifications or additions to
this product, apart from replacement of the spare
parts as described above, are unacceptable, unless
done by the manufacturer.
4. TO BE OBSERVED
PRIOR TO USE
Prior to every use, this product must be subject to
a visual inspection in order to verify its integrity,
readiness for use and proper functioning. Once
the product has been subject to a fall, its use must
be discontinued immediately. If the slightest doubt
remains, the product must be retired or may not be
used again until a duly compentent person, having
subjected such product to the required testing and
inspections, has approved its further use in writing.
It must be ensured that the recommendations for
use with other components be complied with: ropes
need to meet EN 1891, while carabiners need to
meet EN 362. Further PPE components must meet
the harmonized standards under the regime of
regulation (EU) 2016/425. Be sure to observe the
recommendations provided in this instructions for
use document and the specifications contained in
the "Documentation of Equipment".
The compatibility of all components in the load chain
is of critical importance.
Ensure all neighbouring components are compatible.
Ensure all components are correctly configured.
Failure to do so increases risk of serious injury
or fatality.
It is the responsibility of the user that a relevant
and 'live' Risk Assessment is in place for the work
to be carried out which includes emergency contin-
gencies. A plan of rescue measures that covers all
foreseeable emergencies needs to be in place before
this product can be used. Prior to and during use,
rescue measures that can be executed safelyand
effectively must be considered at all times.
5. WARNING
– If there exists only the slightest doubt about the safe
condition of the product, be sure to replace such
product immediately.
SECUrITy / WarNING / TraNSPOrT, STOraGE & ClEaNING
– A system that has been exposed to a fall shall be
retired, or be returned to the manufacturer or a duly
qualified repair shop for maintenance and testing.
– Snow, ice, and moisture may affect the product's
handling and strength.
– Be sure to avoid high temperatures, sharp edges,
and exposure to chemicals (e.g., acids). Rappel
slowly to prevent the generation of great heat. UV
radiation and abrasion have an adverse impact on
the rope and its strength.
– Knots in the rope may cause a significant reduction
of its breaking load.
6. TRANSPORT, STORAGE
AND CLEANING
This product consists of different textile materials:
Two parallel polyester ropes extend inside the pol-
yester cover. In the case of the fImblSAVER, the
interior of the rope forming the friction hitch also
consists of polyester, while on the fImblCLIMB it
is made of Dyneema®. In both cases, the cover
consists of polyester and aramid fibers.
Aramids and Dyneema® are not UV-stable. Sunlight
and chemicals attack the material and cause it to
lose in strength. Because of the polyester content
the product must never be subject to temperatures
of more than 100 °C. Furthermore, Dyneema® must
never be exposed to temperatures above 60 °C.
Reactions like discolouration, hardening are clear
evidence that the product must be removed from
service.
The thimbles are made of stainless steel. Do not
use this product in corrosive conditions.
When transporting the product, it must always
be protected form light and dirt and provided with
suitable packaging (moisture-repellent material that
is impervious to light).
Conditions of storage:
– Protected from light (UV radiation, welding
machines...)
– Dry and clean
– At room temperature (15 - 25 °C)
– Not in the proximity of chemicals (acids, lyes, liquids,
vapours, gases, ...) and other aggressive environ-
ments
– Protected against sharp-edged objects
7