EINHELL 45.137.84 Originalbetriebsanleitung Seite 13

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. On/Off switch
2. Battery
3. Pushlock button
4. LEDs
5. Charging unit
6. Charging adapter
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
Anl_RT_CL_12_Li_SPK1.indb 13 Anl_RT_CL_12_Li_SPK1.indb 13
GB
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
B attery-powered lamp
•
Battery
•
Original operating instructions
•
Safety instructions
3. Technical data
Power supply: .......................................... 12 V DC
Number of LED: ................................................. 7
Battery charge voltage: ........................... 12 V DC
Battery charge current: ................................ 0,6 A
Charging unit supply voltage: .. 230-240 V ~ 50 Hz
Weight: ........................................................0.3 kg
4. Before starting the equipment
Charge the battery pack with the charger sup-
plied. The charging period of an empty battery
pack is completed after approx. 3 hours.
5. Operation
5.1 Charging the battery (Fig. 2-3)
1. Remove the battery pack (2) from the handle
(Fig. 2) by pressing the pushlock buttons (3)
on the left and right side of the battery pack
(2).
2. Check that your mains voltage is the same
as that marked on the rating plate. Plug the
battery charger (5) into the power socket
and connect the charging cable (a) to the
charging adapter (6). The green LED on the
charging adapter (6) then comes on.
3. Plug the battery pack (2) into the charging
adapter. The green LED and the red LED will
come on to indicate that the battery pack is
being charged.
4. When the charging period is completed after
approx. 3 hours, the red lit LED will go out
again.
- 13 -
17.04.15 11:02 17.04.15 11:02