Error Messages On The Display; Technical Specifications - ECG EWT 70120 Bedienungsanleitung

Warning:
• When the appliance is in operation and depending on the selected programme, there may be hot water
in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has
completed the cycle and is empty. When replacing the cover, make sure it is tightened securely.
TROUBLESHOOTING
Description
The washing machine cannot be
started.
The door can't be opened.
Water leakage
Detergent residue on the laundry
or in the drum.
The indicator or display is not lit.
Unusual noise.

Error messages on the display

Error code Cause
E30 The door is not closed properly
E10 Water injection problem.
E21 It takes too long to drain the water.
E12 Water overflow.
EXX Others.

TECHNICAL SPECIFICATIONS

Built-in appliance
Maximum load capacity (dry
laundry) kg
Maximum speed/min.
Dimensions (H × W × D) [mm]
Nominal voltage
Power input
20
Cause
The door is not closed properly.
The washing machine's safety lock
is active.
The connection between the inlet
pipe or outlet hose is not tight.
The detergent is too thick.
Power is disconnected or the
electronics have malfunctioned.
Solution
Start the washing machine after closing the
door. Check that the laundry is not stuck in the
drum.
Check that the water pressure is not too low.
Straighten the supply hose.
Check the inlet valve filter for blockages.
Check that the drain hose is not blocked.
Switch the washing machine off and on again.
Please try starting the wash again. If problems
persist, contact customer service.
EWT 70120
No
7
1200
875 × 400 × 610
220–240 V ~ 50 Hz
2100 W
Solution
Start the washing machine after
closing the door. Check that the
laundry is not stuck in the drum.
Disconnect the power and restart
the washing machine.
Check and fix the water pipes.
Clean the drain hose.
Clean and wipe the detergent
dispenser.
Check that the power is not
switched off and that the plug is
correctly connected.
Check that the fasteners (screws)
have been removed.
Install the refrigerator on a flat and
solid surface.
EWTI 71120
No
7
1200
875 × 400 × 610
220–240 V ~ 50 Hz
2000 W