Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents and not too cold to ensure long-time ad-
herence.
•
Fix the adhesive strips (G) on the back side of
the mounting plate (F) in the provided area. You
should be able to read the letters on the back side
(H) (see figure 2).
•
Remove the protective film from the adhesive strips.
•
Press the assembled push button with the back
side to the wall in the position where it should
subsequently be attached.
5.2.2
Screw mounting
For mounting the wall-mount remote control using
screws, please proceed as follows:
•
Choose a site for installation.
Make sure that no electricity or similar lines run in
the wall at this location!
Position the mounting plate (F) on the desired
•
site on the wall. Make sure that the arrow on the
mounting plate is pointing upwards.
Use a pen to mark the positions of bore holes (I)
•
(diagonally opposite) in the mounting plate on
the wall (see figure 3).
Start-up
35
Werbung
