Werbung
Tab. 53:
Id
Attribute
0x6
Interface Control
0x7
Interface type
0x8
Interface state
0x9
Admin State
0xA
Interface label
Tab. 54:
Id
Attribute
0x64 Ethernet Interface
Index
0x65 Port Control
0x66 Interface Utilization Get
0x67 Interface Utilization
Alarm Upper
Threshold
0x68 Interface Utilization
Alarm Lower
Threshold
UM Config OCTOPUS-8TX HiOS-2S
Release 9.4 07/2023
Instanz-Attribute (Forts.)
Access
Rule
Get/Set STRUCT of:
Get
Get
Set/Get USINT
Get
Hirschmann-Erweiterungen des Ethernet-Link-Objekts
Access
Rule
Get
Get/Set DWORD
Get/Set USINT
Get/Set USINT
Data type
Description
WORD ControlBits 0:
1:
UINT ForcedInter-
Interface speed in Mbit/s: 10,100,...,
face Speed
if Auto-negotiation disabled
USINT
Type of interface:
0: Unknown interface type
1: The interface is internal
2: Twisted-pair
3: Optical fiber
USINT
Current state of the interface:
0: Unknown interface state
1: The interface is enabled
2: The interface is disabled
3: The interface is testing
Administrative state:
1: Enable the interface
2: Disable the interface
SHORT-STRING
Human readable ID
Data type
Description
USINT
Interface/Port Index (ifIndex out of
MIBII)
0:
1:
8:
9:
USINT
The existing Counter out of the private
MIB hm2IDiagfaceUtilization is used.
Utilization in percentage (Unit 1%=100,
%/100). RX Interface Utilization.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmUpper-
Threshold can be accessed. Utilization
in percentage (Unit 1%=100).
RX Interface Utilization Upper Limit.
Within this parameter the variable
hm2DiagIfaceUtilizationAlarmLower-
Threshold can be accessed. Utilization
in percentage (Unit 1%=100). RX Inter-
face Utilization Lower Limit.
Industrieprotokolle
16.3 Funktion EtherNet/IP
Control Bits:
Auto-negotiation enable/disable
(0=disable, 1=enable)
Duplex mode (0=Half, 1=Full),
if Auto-negotiation disabled
Link state
(0=link down, 1=link up)
Link admin state
(0=disabled, 1=enabled)
Access violation alarm (read-only)
Utilization alarm (read-only)
285
Werbung
