Cleaning, Care, Maintenance; Cleaning, Care & Maintenance; How Often Should The Various Parts Be Cleaned; Cleaning The Pressure Cooker - GSW System Rapid Gebrauchsanleitung

GSW-System-Rapid-3-2Liter Seite 30 Donnerstag, 31. März 2022 10:12 10
Caution! Take care to prevent the water jet from
hitting the pressure regulator 6 or the safety
valve 4, as water might otherwise get inside the
pot and dilute your food.
2. Only then slide the lock 8
forwards and simultane-
ously turn the lid anticlock-
wise until the round mark
on the lid is lined up with
the round mark on the pot
handle 10.

7. Cleaning, care, maintenance

Your new pressure cooker is easy to maintain. In
order to enjoy your pressure cooker for a long
time, please ensure you always observe the
following cleaning instructions.
7.1 How often should the various parts be
cleaned?
Activity Frequency Chapter
Clean base After each
12 use
Clean When dirty
pressure
regulator 6
Clean lid 2 After each
use
Clean sealing After each
ring 11 use
Replace When
sealing ring needed,
1 x year

7.2 Cleaning the pressure cooker

Caution! Never use harsh or abrasive cleaning
products, as this may damage the pressure
cooker.
30
3. Remove the lid from the base.
Notes:
• If possible you should clean the pressure
• Do not leave food containing salt, acid,
"7.2 Cleaning the
Base (12):
pressure cooker"
Clean the base 12 after each use:
"7.2 Cleaning the
pressure cooker"
1. Wash the base with hot water and washing-
"7.2 Cleaning the
2. Rinse with clean water.
pressure cooker"
3. Dry the base with a tea towel to avoid any
"7.2 Cleaning the
pressure cooker"
Note: The base is dishwasher friendly.
"Sealing ring
(11):" on page 31
Pressure regulator (6)
The pressure regulator 6 only needs to be
dismantled and cleaned if it has been made dirty
by cooked food boiling too high.
1. Press the pressure regulator 6
2. Pull the pressure regulator out.
Note: As soon as you slide the lock 8
forwards, some residual steam may escape.
cooker directly after use so that any leftovers
do not dry and stick to the base.
sugar or alkaline substances in the pot for
too long. This could result in surfaces
discolouring, though this would not affect the
ability of the pot to function.
up liquid.
water marks.
down whilst simultaneously
turning it to the "Ø" position.