Schwamborn DSM 800RC Wartungsplan Seite 5

Maintenance plan
Follow the safety instructions and procedure in
the operating manual and in the spare parts plans!
If any defects are found in the machine that could
endanger persons or damage property, stop the
machine immediately and ensure that it cannot be
used again until all repairs are completed.
Before starting cleaning or maintenance work:
- End operation!
- Let machine cool down!
When working on the machine (set-up, maintenance,
service, repair, cleaning, etc.), the power supply of the
machine has to be disconnected from the mains
(disconnect power plug)!
Maintenance
Electrical components:
Visual check for damages
Check emergency stop.
Air filter
DIF-Connector, soft with ETX
ETX-carrier
ETX-2-carrier
Check the rubber bushes
Check the rubber plates
2021 - 02
1x/Day 1x/Week Notes
X Attention:
Electric shock and risk of fire due to faulty electrical cables!
Check the power line and power plug regularly for
functional safety.
X
X Regularly replace the air filter on the control box, depending
on the type of grinding work.
X Before starting work check for wear or tear. The grinding
tools must be free of play in the mountings.
X Before starting work check for wear or tear. The grinding
tools must be free of play in the mountings.
Machine without grinding tools must run vibration­free.
If this is not the case, check the ETX­carriers or the connec­
tors.
X The 4 rubber bushes in the 3 tool holders must be renewed
regularly.
Otherwise, the grinding pattern can be impaired and there
can be consequential damage to the tool holders!
X The rubber plate in the 3 tool holders must be renewed re­
gularly.
Otherwise, the grinding pattern can be impaired and there
can be consequential damage to the tool holders!
The operating and maintenance personnel responsible
for the machine must ensure that no one can enter the
machine's danger zone during operation or
maintenance work.
Maintenance work may only be performed by trained
specialists! They must be familiar with the dangers
associated with such work, protect themselves and avoid
danger!
The machine needs to be secured against tipping during
maintenance work!
If necessary, make use of braces.
Keep in mind the weight of the machine and the
machine parts! Secure dismantled parts against falling.
After cleaning and maintenance work, check the safety
equipment for completeness and functionality.
DSM 800RC
15kW
5