Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Access Point first.
To add the blind actuator, please proceed as follows:
•
Open the Homematic IP app on your smart-
phone.
•
Select the menu item "Add device".
•
After installation, the pairing mode of the device
remains activated for 3 minutes.
If the time has exceeded, you can manually re-
start the pairing mode for another 3 minutes by
removing the rocker and pressing the system
button (A) shortly (see figure 9).
•
Your device will automatically appear in the
Homematic IP app.
•
To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
•
Please wait until pairing is completed.
If pairing was successful, the LED (A) lights up
•
green. The device is now ready for use.
•
If the LED lights up red, please try again.
•
Complete the setup of your blind actuator by fol-
lowing the instructions in the app.
•
In the app, give the device a name and allocate
it to a room.
Start-up
47
Werbung
