Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IN S TA LLA TION M A N U A L
9.5.2.2 Flame baffle plate
On delivery the flame baffle plate (see Annex 2, fig. 8) will be lying on the bottom of the appliance.
It must be placed on the accompanying profiles in the top of the appliance.
To do this proceed as follows:
Ø
Take the flame baffle plate and tilt it backwards.
The stainless steel profile must be placed at the front with the screw heads facing the top (see Annex 2, fig. 8).
!Caution
Ø
Lift the flame baffle plate into the top of the appliance.
Ø
Slide the front of the flame baffle plate over the 2 iron supports located at the top, at the front of the appliance
(see Annex 2, fig. 13).
Ø
Then slide the flame baffle plate towards the back and centre it in the appliance.
Ø
The flame baffle plate is now in the correct place.
The removal of the flame baffle plate takes place in reverse order.
9.5.2 Glass panes
•
Avoid damage when removing/fitting the glass pane.
!Caution
•
Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
!Tip
9.5.2.1 Disassembly of glass pane in door
To remove the glass pane in the door, please follow the instructions below (see Annex 2, fig. 11):
Ø
Open the door.
Ø
Lift out the door by sliding it upwards.
Ø
Place the door on a flat surface.
Ø
Remove the door seal.
Ø
Unscrew the nuts under the door seal from the glass strip.
Ø
Remove the glass strips.
Ø
Lift the glass pane out. The pane seal is also taken out.
When replacing the glass pane always replace the glass pane seal in the door (= seal between the glass pane and
!Tip
the door) AND the door seal (= seal between the door and the fire).
9.5.2.2 Disassembly of side panes
The side panes must be replaced in case of cracks or fractures in the glass pane.
Ø
Unscrew the Allen screw (see Annex 2, fig. 12).
Ø
Now follow the steps described in paragraph 9.4.1.1 'Disassembly of glass pane in door'.
The side panes are made of IR glass. This glass consists of a coating that reflects a large part of the infra red
!Caution
radiation (heat radiation). This glass is characterized by a rough and smooth side (coating). It is very important that
the side panes are mounted with the coated side towards the outside.
Mark the coated side of the side panes before disassembling the side pane. This will help you to place back the
!Tip
side panes correctly.
9.5.2.3 Assembly of glass pane in door
Assemble the glass pane in the door according to the steps described in paragraph 9.4.1.1 'Disassembly of glass
pane in door', only in reverse order.
•
Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
!Caution
•
Place the glass pane (including new pane seal) with the logo to the bottom right.
•
Place a new door seal.
•
Slide both ends of the door seal in the supplied sleeve (see Annex 2, fig. 11).
Make sure that the sleeve is placed on the underside of the glass pane.
!Caution
43
Werbung
