Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IN S TA LLA TION M A N U A L
9.4 Appliance-specific information: Instyle Corner 660 Low-01/High-01
9.4.1 Interior lining
9.4.1.1 Vermiculite
The fire's vermiculite plates are located on the bottom and against the side and rear wall of the appliance. In the
following situations the vermiculite plates must be taken out:
•
When disassembling the air slide valve.
•
To be able to reach the adjustable legs.
•
When replacing the vermiculite plates.
The bottom plates and the underlying felt are first removed, then the side plate and the rear plates last.
The insertion of the vermiculite plates takes place in reverse order.
Make sure that the vermiculite plates are placed back in the original position! The back plate, for instance, must be
!Caution
placed with the small, not countersunk, holes towards the front.
9.4.1.2 Flame baffle plate
On delivery the flame baffle plate (see Annex 2, fig. 8) will be lying on the bottom of the appliance.
It must be placed on the accompanying profiles in the top of the appliance.
To do this proceed as follows:
Ø
Take the flame baffle plate and tilt it backwards.
The stainless steel profile must be placed at the front with the screw heads on top (see Annex 2, fig. 8).
!Caution
Ø
Lift the flame baffle plate into the top of the appliance.
Ø
Slide the front of the flame baffle plate over the iron support located at side pane side of the appliance
(see Annex 2, fig. 9).
Ø
Then slide the flame baffle plate towards the vermiculite plate which is located against the side wall.
Ø
The flame baffle plate is now in the correct place.
The removal of the flame baffle plate takes place in reverse order.
9.4.1.3 Restrictor tray
The appliance can be provided with a restrictor tray. This can be used to reduce the draft in the channel. At
delivery, the restrictor tray is located in the fireplace. In case of a duct with a draft that is (too) strong, the restrictor
tray must be installed.
When installing the restrictor tray, proceed as follows (see appendix 2, fig. 17):
Ø
Remove the flame baffle plate (see section 9.4.1.2);
Ø
Unscrew the nuts of the flue gas mouth.
Ø
Place the restrictor tray.
During placement, always make sure that the partitions of the restrictor tray are pointing down.
!Caution
Ø
Fasten the restrictor tray with the three bolts/nuts of the discharge pipe or ring.
Ø
Place back the flame baffle plate.
9.4.2 Glass panes
•
Avoid damage when removing/fitting the glass pane.
!Caution
•
Avoid/remove fingerprints on the glass pane(s) as they will burn into the glass.
Use the supplied glass pane cleaner to remove fingerprints from the glass pane(s).
!Tip
41
Werbung
