Parkside PABH 20-Li C3 Originalbetriebsanleitung Seite 7

High-speed charger PLG 20 A1
INPUT
Rated voltage
Rated power
consumption
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission value
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically:
Hammer drilling
Sound pressure level
Uncertainty K
Sound power level
Uncertainty K
Wear ear muffs!
Total vibration value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Hammer drilling in concrete
Front handle
Rear handle
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
PABH 20-Li C3
230–40 V ∼, 50 Hz (AC)
65 W
T3.15A
3.15 A
21.5 V (DC)
2.4 A
approx. 60 min
II / (double insulation)
L = 97.3 dB (A)
pA
K = 3 dB
pA
L = 108.3 dB (A)
WA
K = 3 dB
WA
a = 14.191 m/s
h(HD)
a = 12,625 m/s
h(HD)
K = 1.5 m/s 2
WARNING!
► Depending on the manner in which the power
tool is being used and, in particular, the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values given in these instructions during
actual use of the power tool.
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on
but running without load).
General power
tool safety warnings
WARNING!
► Read all safety warnings, instructions, illus-
trations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
2
1. Work area safety
2
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or
fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │ CY │
3 ■