Parkside PABH 20-Li C3 Originalbetriebsanleitung Seite 11

Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► The recommended ambient temperature
range for using tools and batteries is between
–5°C and 50°C.
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry, and the ambient
temperature should be between 0°C and
50°C.
♦ Connect the battery pack
charger (see fig. A).
♦ Insert the mains plug into the mains socket.
The control LED
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Checking the battery charge level
♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PABH 20-Li C3
to the high-speed
lights up red.
indicates that the
to
as follows:
Inserting/removing the battery pack
Inserting the battery pack
♦ Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .
Using the appliance
NOTE
► Push the rotation direction switch
middle position before carrying out any work
on the power tool (e.g. maintenance, tool-
changing, etc.) as well as during carriage
and storage of the power tool. Unintentional
activation of the On/Off switch
in injury.
Selecting a tool
■ For hammer drilling, you will need an SDS-plus
drilling tool.
■ For standard drilling in wood, metal, ceramics
and plastic, you can use an appropriate
SDS-plus drilling tool or a tool with a hexagonal
shank.
■ For screwing, use the screwdriver bits
that you can attach using the quick-release
chuck .
into the
and remove the
into the
can result
GB │ CY │
7 ■