Philips HB584 Bedienungsanleitung Seite 7

Press the •/ º button to switch between full intensity and half intensity.
,
During the tanning session, you can press the > button to switch on the body cooling fan for extra comfort.
,
After the face tanner has switched off, you have to wait 3 minutes before you can switch the face tanner back on. During this cool-down period
the symbols near the •/ º button blink.
natural fragrances (HB585 only)
During the tanning session, you can enjoy your favourite fragrance. You can choose from three different fragrances.
The scent granules have been specially developed for use in this appliance. Do not use other granules.
,
Filling the cartridge
1 Pull the cap off the cartridge while you apply pressure on the small pressing points. (Fig. 6)
 Open the sachet at the small opening at the top.
3 Fill the cartridge with the content of one whole sachet of scent granules.
4 Put the cap back onto the cartridge ('click').
placing or removing the cartridge
1 Place the cartridge in the holder. It only fits in one way and locks in place with a click. (Fig. 27)
To remove the cartridge, place your thumb and index finger on the sides of the cartridge. Press on the disc to remove the cartridge
,
from the holder. (Fig. 8)
setting the fragrance level
1 Turn the cartridge to set the fragrance level. (Fig. 9)
Turn the cartridge in the direction of the large flower symbol to increase the fragrance level. Turn it in the opposite direction to reduce the
fragrance level.
 When you store the appliance or do not want it to emit a fragrance, turn the cartridge away from the large flower symbol as far as it
goes. (Fig. 30)
The holes are no longer visible.
3 Replace the granules when the cartridge no longer emits any fragrance. Replacement packages with 3 sachets of scent granules are
available under type number HB080.
Please bear in mind that the fragrance level depends on a number of factors, such as the following:
,
- Habituation may cause fragrances to be perceived less or not at all, but this is normal.
- When your head points to the right, the fragrance is less noticeable than when your head points to the left.
- Airflows in the room where you use the appliance may also affect the fragrance level.
- Your personal condition may also influence the degree in which you perceive the fragrance.
stereo active speakers (HB585 only)
During tanning, you can listen to your own favourite music by connecting your own audio player (e.g. CD/MP3 or radio) to the appliance.
To connect your own audio player to the appliance, use the cable with 2 jack plugs supplied with the appliance.
1 Insert one jack plug into the AUX socket on the right side of the speaker.
 Insert the other jack plug into the headphone socket of your audio player (e.g. CD, MP3 or radio).
You can adjust the volume on your own audio player.
,
- Do not set the volume extremely high, as this could cause irreparable damage to the speakers.
- In fact, we advise you to set the volume lower than you are accustomed to, because the space between couch and canopy works as an
acoustic box and amplifies sound.
cleaning
Always unplug the tanning appliance and let it cool down before you start to clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.
Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the acrylic sheets, as this causes irreparable damage.
1 Clean the outside of the tanning appliance with a damp cloth.
Do not let any water run into the appliance.
 Clean the protective goggles with a moist cloth.
replacement
The light that is emitted by the tanning lamps becomes less bright in time (i.e. after a few years in case of normal use). When this happens,
you notice a decrease in the tanning capacity of the appliance. To solve this problem, set a slightly longer tanning time or have the tanning lamps
replaced.
We advise you to have the tanning lamps replaced after 500 operating hours.
,
Have the tanning lamps and/or starters replaced by a service centre authorised by Philips. They have the knowledge and skills required
,
for this job and the original spare parts for the tanning appliance.
The UV filter of the face tanner (HB585 only) protects against exposure to undesired UV light. It is therefore important to have a
,
damaged or broken filter replaced right away.
The lamp of the face tanner (HB585 only) may only be replaced by a service centre authorised by Philips.
,
If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order
,
to avoid a hazard.
If you really insist on replacing the tube lamps and/or starters yourself, proceed as follows:
,
1 Remove the mains plug from the wall socket.
 Undo the screws and remove the two end covers of the canopy and of the couch. (Fig. 31)
EnglisH
7