Using The Appliance - Philips HP8565 Bedienungsanleitung

5 Push the legs of the appliance under the bed or sofa you intend to lie down on. The lamps for
functions ¼ and × are on the marked side of the appliance (HP8565/HP8560 only). (Fig. 8)
6 Press the release buttons in the recesses of the control panel (1) and push the control panel
upwards along the stand (2). Let go of the release buttons when the lamp unit is at the
required height. (Fig. 9)
- The distance between the UV filters and your body must be 70cm. The distance between the
UV filters and the surface on which you lie (e.g. a bed) must be 90cm. (Fig. 10)
- Pull out the measuring tape to determine whether the appliance is at the required
height. (Fig. 11)
- The measuring tape automatically rewinds when you operate the red tab. (Fig. 12)

using the appliance

tanning or relaxing (HP8550)
1 Fully unwind the mains cord.
 Put the plug in the wall socket.
3 Consult the chapters 'Tanning and your health' and 'Relaxation and your health' for the
correct tanning or relax time.
4 Attach the string to the protective goggles provided.
5 Adjust the string to the length you find most comfortable.
6 Put on the protective goggles.
- Only use these protective goggles when you tan with a Philips tanning appliance. Do not use
them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
7 Lie down straight below the lamp unit of the appliance.
8 Set the timer to the appropriate time for the session. (Fig. 13)
Note: It can take a few seconds for the lamps to go on. This is normal.
The appliance beeps during the last minute of the session.
,
During this minute, you can reset the timer to tan the other side of your body. If you reset
,
the timer during this minute, you avoid the 3-minute waiting time which is necessary to let
the tanning lamps cool down after they have switched off.
tanning or relaxing (HP8565 and HP8560)
1 Fully unwind the mains cord.
 Put the plug in the wall socket.
3 Select a function by pressing the function selection button (see section 'Adjusting functions').
4 Turn the time-selection ring to set the time (see section 'Setting the time for a tanning or
relax session').
5 Attach the string to the protective goggles provided.
6 Adjust the string to the length you find most comfortable.
7 Put on the protective goggles.
- Only use these protective goggles when you tan with a Philips tanning appliance. Do not use
them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
8 Lie down straight below the lamp unit of the appliance.
EnglisH
11