Philips HP8565 Bedienungsanleitung Seite 17

Problem
The top of the control
panel becomes hot
during use.
The fuse of the circuit to
which the appliance is
connected cuts off the
power when I switch on
or use the appliance.
The tanning results not
as good as I expected.
The appliance does not
produce enough
fragrance.
The display shows 'Err'
(HP8565/HP8560 only)
and/or the appliance
beeps.
Solution
There may be a power failure. Test if the power supply works by
connecting another appliance.
The tanning lamps may still be too hot to go on. Let them cool down
for 3 minutes first.
The overheat protection may have switched off the appliance
automatically because it overheated. Remove the cause of overheating
(e.g. a towel that blocks one or more vents). Let the appliance cool
down for a while and then switch the appliance back on.
Make sure the lamp unit is in the right position. See chapter 'Preparing
for use'.
The lamps heat up the top of the control panel. This is normal.
The fuse of the circuit to which the tanning appliance is connected
must be a 16A standard fuse or a slow-blow automatic fuse. You may
also have connected too many appliances to the same circuit.
Perhaps you use an extension cord that is too long and/or does not
have the correct current rating. Consult your dealer. Our general
advice is not to use an extension cord.
You may have followed a tanning course that is not appropriate
for your skin type. Check the table in chapter 'Tanning and your health',
section 'Tanning sessions: how often and how long?'.
The distance between the lamps and the surface you lie on may be
larger than prescribed. See chapter 'Preparing for use'.
When the lamps have been used for a long time, the tanning
capacity decreases. This effect only becomes noticeable after several
years. To solve this problem, select a slightly longer tanning time
or have the lamps replaced. HP8565/HP8560 only: after 750 operating
hours, an L appears on the display which tells you that it is advisable to
have the lamps replaced.
The tanning result depends on your skin type and the tanning course
you are taking. The first effect only becomes visible after a few
sessions.
Read the last part of section 'Natural fragrances' in chapter 'Using the
appliance'.
Stop using the appliance and unplug it. Wait two seconds and put the
plug back into the wall socket. Contact your dealer or a Philips service
centre if the problem reoccurs.
EnglisH
17