Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Before beginning installation, to better handle the hood, we advise removing the aluminum filter.
Before fixing, the outlet exhaust duct for air evacuation to the outside must be installed.
Use an outlet exhaust duct with:
- Minimum indispensable length;
- Minimum possible bends (maximum angle of bend:¬ 90°);
- Certified material (according to local, building & fire regulations); and as smooth as possible inside.
It is also advisable to avoid any drastic changes in duct cross-section (recommended diameter:
150mm).
Drill the hole in the wall for the air outlet (160 mm diameter) referring to drawings here on the right
where the measurements for the various possibilities are indicated.
Decide on the position of the hole for the air outlet:
The hole must be in the ceiling, according to your requirements, but must be in vertical line with your
hood. Bear in mind that the hood can expel air through the top air outlet only.
Fitting under cabinet
1. Before fixing the hood to cabinet, drill a hole of 160mm diameter in the wall unit.
2. In any case, check the position of the power outlet considers where the power cable will run, since
a hole might have to be made in the cabinet to accommodate it.
3. Drill 4 mounting holes with ø4 in cabinet board, respecting the distance indicated..
4. Lift the hood up and tighten with four M4x35mm screws from the top of the cabinet board.
5. Make the electrical connection.
21
Werbung
