Swegon ESENSA Installationsanleitung Seite 7

Step 1 (green hose)
Disconnect the hose between the pressure sensor/stat "E"
(component G1/2 - Picture 3) and the pressure tapping "F"
(component R1/R2 - Picture 3).
Install the T-connector provided in the kit (kit n°5).
Use the green hose supplied in the kit (kit n°2).
It must be cut to the needed length connect the two parts of
the T-connector.
• One piece of tubing connects the T-connector and the "F"
pressure tapping.
• The other piece connects the T-connector and the defrost
box on the inlet +.
Please respect the colour of the pipes.
Cut the appropriate length of pipe.
In addition to installing and connecting the option, configure the unit's option using the commissioning manual.
We reserve the right to alter specifications.
MULTI.ESENSA.DEFROST.230821
Step 2 (transparent hose)
Disconnect the hose from the sensor box "E. Cut transparent
hose near the "E" sensor box to insert the
provided in the kit (kit n°5).
Use the corresponding hose supplied in the kit (kit n°2). It must
be cut to the length required to connect the two parts of the
T-connector.
• One piece of tubing connects the T-connector and the
sensor box "E".
• The other piece connects the T-connector and the defrost
box on the input -.
Observe the colour of the pipes.
Cut the necessary length of pipe.
Step 3 (red control cable)
Connect the sensor box "S" and the defrost box using the RJ12
cable provided in the kit (kit n°1).
Use the free terminal insideof the sensor boxes "S" and one of
the ports on the defrost box.
T-connector
www.swegon.com 7