Swegon ESENSA Installationsanleitung Seite 5

6. Defrost kit installation
picture 4
picture 5
We reserve the right to alter specifications.
picture 6
MULTI.ESENSA.DEFROST.230821
Open the electric cabinet by unscrewing the panel (picture 4).
Place the defrost sensor box in position on the unit, provided
in the kit (kit n°3) and use the screw to fix it on the threaded
tubes (already present). Use the M5 hex screw to attach the
box on the unit (kit n°4).
The cover of the box must be oriented towards the doors and
the pressure sensors entries must be positioned downwards)
(picture 5).
Open the defrost sensor box. Change the selection wheel inside.
Using a screwdriver, position the point of the arrow on the
letter "C"(picture 2).
Check the position of the pressure sensors/stats labelled "E"
(Extraction)(component G1/2 - picture 3 - page 4). It must
indicate 150 Pa (picture 6).
To connect the defrosting kit, see wiring diagram (picture 8).
www.swegon.com 5