Dealer Service & Adjustment; Positioning And Growth Adjustments; Comfort Seat Adjustment - Zippie VOYAGE Besitzerhandbuch

IX. DEALER SERVICE & ADJUSTMENT
A. POSITIONING AND GROWTH ADJUSTMENTS
WARNING
If a change in adjustment is necessary for growth or positioning, a healthcare
professional must be consulted before any changes are made. These adjustments are
very important to the orthopedic and neurological needs of the child. Care should be
taken to make sure the changes are physiologically and medically appropriate. Sunrise
Medical suggests that any positioning or growth adjustments be made by your service
provider. Do not allow any adjustments while the child is seated in the mobility device.
Tools you will need:
To set-up, adjust and maintain your device you will need the following tools:
1. 4.0 mm hex key for most growth adjustments on the Voyage.
2. 10mm open end wrench
3. Torque Wrench
If you plan to adjust and maintain this device yourself, Sunrise recommends that
you use a torque wrench.
NOTE: The torque wrench must measure inch-pounds. You may buy a torque wrench
and proper metric sockets from any local hardware store.
In general, positioning and growth adjustments should be done in the following order:
1. Adjust seated area
2. Adjust back support area
3. Adjust pelvic positioning belt
4. Adjust footrest
5. Adjust head support(s)
6. Make other standard and optional adjustments that are needed
7. Check to be sure that all adjustment screws are torqued to specifications
B. COMFORT SEAT ADJUSTMENT
Comfort seat depth adjustment:
NOTE: Seat Plate viewed from underneath.
1. Remove the seat cushion. It is attached with Velcro®.
2. Loosen the screws (A) on both sides (do not remove).
3. Loosen four nuts (B); hardware may need to be removed for certain adjustments.
4. Adjust the depth by sliding front seat pan in or out.
5. Re-tighten fasteners (A) & (B).
6. Place seat cushion back on the seat.
23a
A
23 23
E N GL I SH
23a
B
MK-100301 EU_EN_Rev. 6.0 - US Rev. F