Caster Wheels; Rear Wheels; Parking Brake Operation - Zippie VOYAGE Besitzerhandbuch

VIII. SET–UP & USE
B. CASTER WHEELS
Installing and Removing the Caster Wheels:
1. Locate the caster stem guide hole location on the bottom of the Voyage frame.
Line up the caster stem (A) with the hole and insert, push until the caster stem
clicks into place. Check the secure engagment to the base by pulling on the
caster wheel. If it does not move the caster wheel has been installed properly.
Repeat this procedure for other side.
2. To remove the caster wheel, press Gray button (B) and slide the caster wheel out.
9
Caster Wheel Locks:
1. To lock the caster wheel, Press down on the black button (C) and hold while
sliding the Gray lever (D) to the centre locking point. Do this with both of the
front caster wheels, and check to insure that the lock has been engaged.
2. To engage the swivel wheel, press down on the black button (C) and slide the Gray
lever (D) to the right or left of the center-point. Repeat for the other side. Figure 9
shows the Gray lever in the swivel position.
C. REAR WHEELS
Installing and Removing the Rear Wheels:
1. To install rear wheel, gently slide the rear wheel's axle into the hole in the frame
until the wheel clicks into place.
2. To remove the rear wheel, simply press the wheel button (E) while gently sliding the
wheel away from the frame.
D. PARKING BRAKE OPERATION
Engage or Disengage the Parking Brake:
1. Engage the parking brake by gently pulling the brake lever(F) into an upright
position until it clicks into place.
2. To release the parking brake, pinch the Gray tabs (G) and pull up towards you. Once
released, pivot the brake lever down until it is parallel with the frame.
MK-100301 EU_EN_Rev. 6.0 - US Rev. F
8
10
11 12
18 18
E N GL I SH
B
A
C
E
F
G
8
9
D
10
11
12