Set-Up & Use; Unfolding And Folding Base Frame - Zippie VOYAGE Besitzerhandbuch

VIII. SET–UP & USE
A. UNFOLDING AND FOLDING BASE FRAME
WARNING
1. Zippie dependent mobility devices are designed for stability and performance. When
unfolded, the device must be fully open and locked to avoid injury to the dependent
rider.
2. Follow the instructions for unfolding the device carefully, and double-check that the
device is fully locked before adding the seating shell and rider.
3. Be careful not to trap or pich your fingers.
4 5
Unfolding:
1. Unsnap the storage lock (A) from around the folded frame. It should remain
attached to the frame for future use.
2. Pull the top and bottom of the frame in opposite directions to open the frame and
upholstery.
3. Set the Frame and upholstery down on a flat surface, and push down on pivot point
(B) until there is an audible "click" to lock the frame.
4. Rear wheels and front casters can now be attached if they are not attached already.
7 5 4
Folding:
WARNING
The Voyage is not intended to be folded with the seating system installed. ALWAYS
remove the seating system prior to folding the base. Failure to do this may damage the
product.
1. Remove the child from the seating shell, then remove the seating shell (refer to sub-
section (F)
2. Pull up on both fold handles (C) at the same time with a gentle tug. This action will
release the frame lock. Continue pulling up on the fold handles until the frame is
fully collapsed. It may be necessary to push the handle and caster ends of the frame
together with light pressure.
3. Snap the storage lock (A) around the upper frame to prevent the frame from opening
when transporting, or storing the frame.
4. If required use the additional folding strap provided with the stroller.
NOTE: Rear wheels, or front casters do not have to be removed for this procedure, but
may be removed to save space for storage.
If you decide to leave the front casters on the device, it may not lock correctly due to
interference between the caster wheels and the push handle.
In most cases you should fully retract the push handle before folding, then you will be able
to snap the storage lock easily. Do not force the base open or closed if it sticks during
unfolding or folding, damage could occur.
6
17 17
E N GL I SH
A
B
MK-100301 EU_EN_Rev. 6.0 - US Rev. F
4
5
6
7
C