Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Troubleshooting
Failure
If the cooler does not operate
(No noise or just the fan
noise)
Internal temperature of the
appliance is high
Internal temperature of your
appliance is very low
Excessive perspiration inside
the appliance and on the
window.
Power ratings of the lamps or LEDs used in your products are specified on the plate inside the cooler or in the
installation area of the lamps. Lamps and LEDs used in your products shall only be intervened by Authorized
Services.
7. Compliance with AEEE regulations and waste disposal
1. This product does not contain the dangerous and prohibited materials indicated in "Waste Electrical and
Electronic Equipment Control Regulation" published by Ministry of Environment and Urbanisation of
Republic of Turkey. Complies with WEEE Regulations.
2. This product was manufactured from recyclable and reusable high quality parts and materials. Therefore,
do not dispose of this product with other domestic wastes at the end of its life cycle. Take it to a collection
point for electrical and electronic equipment. You can ask your local administration about these collection
points. You can help protect the environment and natural resources by delivering the used products for
recycling. Before disposing of the product, cut the power cord and break the locking mechanism to make it
inoperable for children's safety.
PACKAGE INFORMATION
The product's packaging is made of recyclable materials, in accordance with the National Legislation. Do not
dispose the packaging waste with the household waste or other wastes, dispose it to the packaging collection
areas specified by local authorities.
Follow the instructions specified in the manual.
If the appliance is still not running normally despite checkouts you have made, call for authorized service.
Possible solution
It may be caused by the thermostat. It
may be unplugged. Fuse may be
blown or faulty. Condenser fins may
be dirty or clogged.
Ambient temperature is very high or
thermostat setting is incorrect. Rear
part is very close to the wall,
ventilation blinds are blocked or its
front is covered. It may be exposed to
excessive external wind. Condenser
fins are very dirty
Wrong internal thermostat setting
Water drainage hole may be clogged
for internal perspiration. Humidity
level of external environment is
higher than 65% for perspiration on
the window.
www.combisteel.com
Result
It shall operate again when it
reaches the proper temperature.
Plug it correctly. Consult authorized
service or a qualified electrician
Take your cooler to a place where
ambient temperature is lower. Bring
it to specified clearance. Clean the
front of the ventilation blinds.
Prevent wind. Clean the condenser
fins.
Reset the thermostat.
lean the water drainage hole. For
high humidity conditions, you may
place your cooler in a location with
less humidity.
14
Werbung
