Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Installation and operation of the cooler
4.1 Location
Possible Installation Locations:
1- Ensure that a clearance of 150 mm (15 cm) is available between the wall and your cooler so that solely the
back of your cooler faces the wall.
2- When you place it on the corner, leave a clearance of 150 mm (15 cm) on its back so that it faces the corner.
You may lean the side on the corner to the wall. (Figure 4)
The most important point for any kind of placement is that the ventilation of the compressor assembly is not
blocked. Place your product so that it is not inclined in any way and that it is standing on its legs or castors and
then operate it. (Figure 5)
Your appliance shall operate more efficiently when the ventilation of the compressor assembly is better.
4.2. Installation
Take off and remove all package materials and lower wooden pallet of your product before placing it. (It may be
required to lift the cooler to remove the base bracket). For the weight of the product, please see the technical
table.
Install spare parts provided inside your appliance as per the installation instructions. Use only genuine spare
parts. Non-genuine spare parts may cause risks for you and may damage your product.
Place your product where you desire. Consider the placing rules specified in the manual during placement.
Level your product laterally and vertically with a spirit level. Perform the levelling procedure with the adjustable
legs on the front lower part of your cooler.
4.3. Operation of the cooler
Rules for Electrical Connection
Your appliance shall operate when you plug it to an outlet.
ATTENTION!
Do not plug your appliance to a multi-socket or do not use an extension cord. Your product is not equipped with
an on/off switch. Do not allow the cables of your product connected to the mains to contact hot surfaces. Outlet
that shall be used shall always be grounded. The outlet to be used should also be protected with a proper fuse
with a rating of 16 A minimum. Always get support from our authorized service or a qualified electrician for the
fuse that shall be installed on the electrical installation where the outlet is connected. (Figure 6)
The voltage and frequency of mains power should be the same as the values specified on the label on the inner
surface of your appliance. If mains power is far below or above the specified value, have the desired voltage by
using a voltage regulator. You can get help from a qualified electrician. Do not put the cable of your product on
passage routes. These may cause injury to you and damage to your cooler.
11
www.combisteel.com
Werbung
