Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.4. Thermostat setting
Temperature settings of your cooler is performed in our factory for operation in suitable conditions.
Temperature for the preservation of the food is adjusted with the thermostat by observing it from the
thermometer on your cooler (optional). Internal temperature of your cooler may be adjusted by rotating the
thermostat switch. Position "7" on the thermostat shall decrease the internal temperature to the minimum level.
Internal temperature of your appliance may be set between -16°C and -24°C.
Putting Food on Your Cooler
You may load the any food you desire as per the examples provided in this manual in your cooler when the cooler
has reached the desired temperature as empty. (If your product model is equipped with a thermometer, you may
control the internal temperature here. Always consider the maximum load capacity while loading frozen food in
your product. Do not exceed the loading mark on your product.
WARNING: Operate your appliance three (3) hours without load before loading your food. Do not put materials
that shall not be cooled in your product. The basket carriage capacities used in your appliance are specified below.
4.5. Defrosting operation
High temperatures and humidity and frequent operation of your appliance may increase the rate of frost. The
more the frost, the more the operation time. And this causes an increase in the power consumption. Turn off
your appliance and make sure that the frost is removed in such a case.
You can scrape ice and snow with the ice-scrabble that comes with your appliance. If the ice layer is too thick to
scrape, put the products in the cooler in a secure place to avoid decaying. Then unplug the cooler. Leave the
windows open for 3-4 hours. Remove the dissolved ice with scrabble. After it is completely cleaned, put the
glasses on again and plug it. After running for 3 hours, put your frozen products inside.
5. Cleaning, maintenance and transportation of your cooler
5.1 Cleaning
Cleaning of your product consists of two stages, namely internal cleaning and external cleaning.
Always follow the warnings below before starting the cleaning operation.
WARNING:
•
Always unplug your cooler before any cleaning operation.
•
Always wear protective gloves during cleaning and maintenance. This will protect you against injuries.
•
Never use domestic cleaning agents and abrasive - scratching material to clean (flammable, ignitable and
abrasive materials such as surface cleaners, detergents, fuel oil, thinner, acids, etc.). Otherwise,
discolouration may occur on the plastic parts of the product
www.combisteel.com
12
Werbung
