Corrective Action - Capitani Multi Cap Bedienungsanleitung

Problem
When the dispensing
buttons (A-B-C) are
pressed, no beverage
comes out.
The capsule is not
ejected
Problem
Coffee/tea is no longer dispensed
It is not possible to dispense coffee,
tea, or boiling water
Coffee/tea is cold
The pump is too noisy
A few drops come out of the
dispenser, especially when the
machine is warming up
Coffee tastes sour
The capsule adheres to the infuser
as it opens
The foamed milk is not very
compact.
The milk is not hot
The button (16) flashes
intermittently.
Solution
1) Fill the tank with water
2) Check if the water tank is well located.
3) Lift the lever to permit air outlet take the capsule
off and wait for a while to let the pump be cool.
Press the dispensing buttons (A-B-C)
If you cannot solve the problem, youare kindly
requested to contact your service center.
Close the lever (1) and open it again slowly, pushing it right back.
Press a dispensing button (A-B-C) and slowly open the lever (1) while
the water is being dispensed.
Causes
- the tank is empty
- the pump is defective
- the capsule is not (fully) pierced
- the water tank is not fully seated
- the pump is defective
- the heating system is defective
- the tank is empty
- the water tank is not seated properly
- the capsule is not (fully) pierceduse
a new capsule
- this is not a fault
-the machine was not rinsed properly
after descaling
- the coffee sell by date has expired
- The capsule was not expelled
immediately after the drink was
dispensed
Cappuccino attachment (21) not
clean
Red O-rings of the connector are
worn
500 litres have been used and it is
necessary to change the water
softener filter (20)
29
19

Corrective action

- fill the tank
-call the service centre
- use a new capsule
- seat the tank properly
- call the service centre
- call the service centre
- fill the tank
- seat the tank properly
- use a new capsule
- it is normal for a few drops to
come out, this is not a defect
- re-rinse the machine
- use a new capsule
- Close and open the lever with
a dispensing button (A-B-C)
operating.
Dismantle the cappuccino
attachment and clean it
accurately.
Check the seal of the red O-
rings of the connector and
replace them if necessary
Change the filter (20) and reset
the machine as indicated on
page 21