Capitani multi cap Bedienungsanleitung Seite 26

Programming the dispenser buttons
Large cup: Press and hold down the button (C). The
machine will start to dispense water. Once the desired
level of water has been reached, release the button
(C). The machine will stop dispensing water and will
store the quantity in its memory for future dispensing.
(Fig. 11)
Medium cup: Press and hold down the button (B). The machine will start to dispense water.
Once the desired level of water has been reached, release the button (B). The machine will stop
dispensing water and will store the quantity in its memory for future dispensing. (Fig.11)
Small cup: Press and hold down the button (A). The machine will start to dispense water.
Once the desired level of water has been reached, release the button (A). The machine will stop
dispensing water and will store the quantity in its memory for future dispensing. (Fig.11)
Making coffee/tea/drinks
NOTE: You can use one of the two units or both together.
•Only use capsules specific for this model
•Place the cup under the coffee dispenser
•Lift the control lever (1) backward (up to stop point) and insert a capsule in the dedicated housing
(Fig.12)
IMPORTANT:
Before inserting the capsule, slowly lift the control lever (1) located on
the top of the machine.
For correct hygiene it is advisable to eject the capsule immediately
after dispensing: to do this, completely open the lever (1) as far as
it will go
• Close the lever (1) (Fig. 13) completely and press one of the dispensing buttons: short (A),
medium (B) or long (C) according to your taste (Fig. 11).
• To extract the capsule, slowly lift the lever (1) and push it right back.
If the capsule is not ejected, repeat the operation or press one of the dispensing buttons (A-B-C)
and lift the lever (1) at the same time.
USEFUL TIP:
• Use thick cups when preparing Espresso and try to heat them beforehand. This will keep your
coffee warm for longer. Cups can be heated on the special shelf (11)
Fig. 12
C
Fig. 11
24
B
A
eject
open
Fig. 13