Clas Ohlson RD-40 Bedienungsanleitung Seite 5

Assembling the fan head
1. Undo the locking ring and
extend the pedestal tube.
Tighten the locking ring again.
2. Undo screw A and
place the fan head onto
the pedestal tube. Tighten
screw A.
3. Undo the locking ring and
adjust the fan to the desired
height. Tighten the locking
ring again.
Fitting the fan blade and safety grille
1. Remove the lock nut (5)
from the rear safety grille.
2. Pass the rear grille
(6) over the drive
shaft on the front of
the motor and align it on
the locating pins.
3. Secure the rear grille
using the rear grille
lock nut.
4. Thread the fan blade onto
the motor drive shaft.
Tighten the lock nut (3).
5. Hook the top of the front half of the safety
grille onto the rear safety grille and lock the
two halves of the grille together by passing
the screw through the hole at the bottom
and fitting the nut.
6. Bend the four clips on the front safety grille
down over the edges of the rear grille.
Pedestal
extension
tube
Locking ring
Grille nut Locating pins
5
Screw A