Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
Caurse
Dishwasher will
Fuse blown, or the circuit
not start
breaker tripped
Power supply is not turned on
Water pressure is low
Door of dishwasher not
properly closed .
The water is not
Twisted or trapped drain hose.
pumped out
Filter clogged.
Kitchen sink clogged.
Foam in the tub
Wrong detergent
Spilled rinse-aid
Rust on the cutlery
The affected items are not
corrosion resistant.
A programme was not run
after dishwasher salt was
added. Traces of salt have got
into the wash cycle.
The lid of softer is loose.
Knocking noise
The spray arm is knocking
against an item in a basket.
Rattling noise
Item of crockery are loose in
the wash cabinet
Knocking noise in
This may be caused by on- site
the water pipes
installation or the cross-
section of the piping.
The dishes are not
The dishes are not loaded
clean
correctly
The programme was not
powerful enough.
Not enough detergent was
dispensed.
Item are blocking the path of
spray arms.
The filter combination in the
base of wash cabinet is not
clean or is not correctly fitted.
This may cause the spray arm
jets to get blocked.
Solutions
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the wall
socket.
Check that the water supply is connected properly and the
water is turned on.
Make sure to close the door properly and latch it.
Check the drain hose.
Check the filter system.
Check the kitchen sink to make sure it is draining well. If the
problem is the kitchen sink that is not draining , you may
need a plumber rather than a serviceman for dishwashers.
Use only the special dishwasher detergent to avoid suds. If
this occurred, open the dishwasher and let suds evaporate.
Add 1 liter of cold water to the tub. Close and latch the
dishwasher, then Start any wash cycle to drain out the
water. Repeat if necessary.
Always wipe up rinse-aid spills immediately.
Avoid washing items that are not corrosion resistant in the
dishwasher.
Always run the Quick wash programme without any crockery
in the dishwasher and without selecting the Turbo function
(if present), after adding dishwasher salt.
Check the softener lid is secure.
Interrupt the program, and rearrange the items which are
obstructing the spray arm.
Interrupt the program, and rearrange the items of crockery.
This has no influence on dishwasher function. If in doubt,
con- tact a suitably qualified plumber.
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can rotate freely.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the Spray cabinet is
not clean or Arms".
Werbung
