Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If dishwasher is installed at the corner of the cabinet, there should
be some space when the door is opened.
NOTE:
Depending on where your electrical outlet is, you may need to cut
a hole in the opposite cabinet side.
Step 2. Dishwasher installation steps
Please refer to the specified installation steps in the installation
drawings.
Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
Connect the inlet hose to the cold water supply.
Connect the drain hose.
Connect the power cord.
Place the dishwasher into the cabinet.
Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by
turning the Philips screw in the middle of the base of dishwasher use an Philips screw
driver. To adjust the front feet, use a flat screw driver and turn the front feet until the
dishwasher is level. (Step 5 to S
Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)
Adjust the tension of the door springs by using an Allen key turning in a clockwise motion
to tighten the left and right door springs. Failure to do this could cause damage to your
dishwasher. (Step 11)
The dishwasher must be secured in place. There are two ways to do this:
A Normal work surface: Put the installation hook into the slot of the side plane and secure
it to the work surface with the wood the screws.
B Marble or granite work top: Fix the side with Screws.
Dishwa
Cabi
Door
of
dishw
asher
Werbung
