Settings - PCE Instruments PCE-VT 3900-ICA Bedienungsanleitung

ATTENTION:
Verify that the required reference vibration is generated by the vibration calibrator before the
calibration is performed!
If the current measurement value compared to the reference vibration exceeds the desired
tolerance, a calibration can be carried out by pressing the OK
subsequent dialogue.
The calibration is performed automatically and should take only a few seconds. After a successful
calibration, the hint "Calibration successful" pops up. The device then returns to the measurement
screen.
5.8

Settings

5.8.1 Units
In the sub menu Units, you can choose either the International System of Units (SI) or the Anglo-
American unit system (US).
5.8.2 Decimal separator
As decimal separator for the readings, you can either select a dot or a comma.
5.8.3 Date & time
This menu is used to change the date and time. The date format can also be changed.
Fig. 11 Calibration screen
Fig. 12 Confirmation dialogue
© PCE Instruments
46
key and confirming the