Husqvarna K1270 II R Bedienungsanweisung Seite 17

There is a risk for eye injury, especially if a
spring is broken.
1. Remove the bolt in the center of the starter pulley
and remove the starter pulley. Carefully remove the
cover.
The recoil spring has tension in the starter housing.
2. Carefully remove the spring. Use a pair of pliers.
To lubricate the spring assembly
• Lubricate the recoil spring with light oil.
To attach the spring assembly
• Assemble in the opposite sequence of
the spring assembly on page 16 .
1390 - 001 - 10.01.2020
To install the starter housing
1. Put the starter against the product.
2. Install the starter pawls into the correct position
against the starter pulley sleeve. Pull out the starter
rope approximately 0.5 m. (A). If the position is
correct, you hear a click sound (B).
B
3. Slowly release the starter rope.
To remove
CAUTION:
The starter pawls must
come into the correct position against the
starter pulley sleeve.
A
17