Husqvarna K1270 II R Bedienungsanweisung Seite 13

Maintenance
Examine the starter hous-
ing.
Examine the fuel system.
Examine the air filter.
Examine the drive gear and
the clutch.
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To clean the cold air intake
Note:
A dirty or blocked air intake makes the product
too hot. This can cause damage to the piston and
cylinder.
• Clean the cold air intake if it is necessary.
• Remove blockage, dirt and dust with a brush.
To examine the spark plug
Note:
Always use the recommended spark plug type.
Use of the incorrect spark plug can cause damage to the
piston and cylinder. For recommended spark plug refer
Technical data on page 21 .
to
Examine the spark plug if the product is low on power,
does not start easily or if it operates unsatisfactorily at
idle speed.
1390 - 001 - 10.01.2020
Daily Weekly
X
1. Loosen the 3 screws on the air filter cover and
remove the air filter cover.
2. Make sure that the spark plug cap and ignition cable
are not damaged to prevent the risk of electrical
shock.
3. Clean the spark plug if it is dirty.
4. Make sure that the electrode gap is 0.5 mm.
Monthly
X
X
X
13