Cleaning And Care - Clatronic HT 2668 Bedienungsanleitung

• If the hair dryer is used in the bathroom, remove the mains plug after use as water
represents a hazard. This also applies when the hair dryer is switched off.
• Do not put objects, hair or your hands in front of the air intake opening! The device can
suffer damage despite the overheating protection if the airfl ow is blocked!
• As additional protection we recommend the installation of a fault current protection
device (RCD) with a rated current of not more than 30 mA in the wiring system of the
bathroom. Please contact an authorised electrician for advice.
1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the mains voltage match.
3. Fit on the nozzle. You can dry single hair locks by concentrating the fl ow of hot air with
the hairdressing nozzle.
4. Insert the plug into a duly installed 230 V/50 Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels: Net weight
6. After use shift the switch to position „0" and pull out the plug. Leave the device to cool
before putting it away! To this purpose place the device on one side of the housing or
hang it up by the suspension lug.
• Clean the air suction opening from time to time with a fi ne brush.
• Clean the housing with a soft, dry cloth without additives.
• The device must never be immersed in water!
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this may result in the cable
breaking.
• Check the mains cable regularly for damage.
05-HT 2668 New.indd 31 05-HT 2668 New.indd 31
WARNING! The nozzles become hot during operation.
Level 0: off
Level 1: medium airfl ow and medium temperature
Level 2: strong airfl ow and high temperature
Commissioning

Cleaning and care

GB
31
05.06.2008 15:24:24 Uhr 05.06.2008 15:24:24 Uhr