Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Clean
Clean the interior and all internal accessories with lukewarm water and some neutral soap
before first use to remove the typical smell of a brand new appliance. Dry everything
carefully. Do not use solvents or abrasive powders; these will damage the coating.
5. Wait
Wait four hours before connecting the appliance so that the oil can flow back to the
compressor.
6. Switch on
Before plugging in the power cable, check that the voltage and frequency of the type plate
match your power supply network. The appliance must be earthed. The power cable is
supplied with an earthed plug for this purpose. If the socket is not earthed, connect the
appliance to a separate earth according to current regulations and consult a qualified
electrician. Insert the mains plug into the socket to start the compressor. After 1 hour, open
the freezer door. If the temperature in the freezer compartment is noticeably lower, this
indicates that the cooling system is operating normally.
7. Mounting accessories
- Adjustable shelves
The walls of the appliance are equipped with a series
of guide profiles so that the shelves can be inserted if
desired.
- Installing the door compartments
To store food of different sizes, the door
compartments can be set to different heights. Proceed
as follows: gradually pull the compartment in the
direction of the arrows until it comes loose and put it
in the desired position.
8. Storing food
See Section 4 "Use".
37
Werbung
