Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Remove the contents from the freezing-compartment and put them into a
cooling box.
2. Switch off the appliance by turning the thermostat to position 0 / AUS / OFF
and disconnect it from the mains or use a cut-off device.
3. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
4. Do not use hot water to accelerate the defrosting operation.
5. Remove the big pieces of ice first.
6. Afterwards remove the small pieces of ice.
7. Wipe and dry the appliance and door seals with dry and soft cloths.
8. After cleaning leave the door open for some time to ventilate the appliance.
5.2 Replacing of the illuminant
WARNING! The LED-illuminant must be replaced by a competent
person only. If the LED-illuminant is damaged, please contact a qualified
professional (not covered by the guarantee).
6. Trouble shooting
POSSIBLE CAUSE
1. The plug of the appliance is not
connected to the socket.
2. The plug has become loose.
3. The socket is not supplied with
energy.
4. The fuse is switched off.
5. The voltage is too low.
1. Incorrect energy supply.
T
1. The appliance has been switched off 1. The appliance needs some time to
MALFUNCTION
T
HE APPLIANCE DOES NOT WORK AT ALL
T
HE COMPRESSOR DOES NOT WORK AT ALL
HE COMPRESSOR OPERATES FOR TOO LONG
MEASURE
1. Connect the appliance to the mains
properly.
2. Check the plug.
3. Check the corresponding socket by
connecting it with another appliance.
4. Check the fuse box.
5. Compare the data on the model
plate with the data of your energy
supplier.
1. Check the energy supply.
88
.
.
.
Werbung
