Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Limit value setting
In order to see whether the material thickness value is within
the tolerance, a top limit and a bottom limit can be set. When
the limits are exceeded / fallen below, the reading will be
shown in red instead of green when the probe is removed. To
set the limit values, go to the main menu with F3
and select "Test Settings". Here, you can find the settings
"Bottom Limit" and "Top Limit". With F1
can select the decimal place and the limit can be set with
. Confirm your entry with F3
Resolution
You can select one of these three resolutions: 0.1 mm / 0.01 mm / 0.001. If you select 0.001 mm,
the surface of the workpiece should be very smooth. When the surface is coarse, a low resolution
is recommended. To set the limit values, go to the main menu with F3
Settings". Here, you can find the resolution setting. Select the desired resolution with F2
your entry with F3
.
Memory Manager
Save
When you press the Save
last data record.
View
The saved data records can be viewed on the meter's display.
To view these records, go to the main menu with F3
and select "Memory Manager". With the
navigate to the data set and select it by pressing F3
data set, all data records are shown and can be deleted
individually by pressing F3
.
Select data set
To select a data set, go to the main menu by pressing F3
Setup and select "Memory Manager" where you can navigate
to the desired data set with the
In the menu that opens, select "Set". The readings will now be
saved to the data set. In the menu, you can also delete the
sets or an individual set.
Setup
and F2
, you
.
key, the current reading will be saved to the selected data set as the
keys, you can
or completely by pressing F2
keys and press F2
© PCE Instruments
27
Setup and select "Test
Setup
. In the
.
. Confirm
Werbung
Inhaltsverzeichnis
