Hendi HND298060 Bedienungsanleitung Seite 6

Special safety features
IMPORTANT: This machine has a specially de-
signed safety feature: Protective cover (10).
Preparations before installation
• Remove all protective packaging and wrapping.
• Check the machine for completeness and
transport damages. In case of incomplete de-
livery (e.g. jug lid, etc) or damage, contact sup-
plier immediately. DO NOT use the machine.
(See ==> Warranty).
Installation
• Read this manual thoroughly and carefully be-
fore installation and operation.
• Ensure the machine is placed in a dry area and
that the surface has sufficient strength to sup-
port the appliance. Also ensure that there are
no obstructions nearby during operation of the
appliance.
Transportation
• Do not move the machine while it is under op-
EN
eration. Unplug the machine when moving the
machine.
Operation
Note: For safety reason, the appliance can only start to operate with the jug set (6) installed properly on
the motor unit (5) and when the protective cover (10) is closed properly.
• Check if the power switch (1) is at the "0" po-
sition and turn the speed dial (2) to "Low" po-
sition.
• Unplug the machine and open the protective
cover (10), take out the jug set (7) from the mo-
tor unit (5).
• Pour all the ingredients into the jug (7) and
close the lid (8) and place the cover cap (9) cor-
rectly in place.
Speed dial (2) setting
Low speed
High speed
Pulse function (0 / II)
After use, always turn the power switch (1) to "0" position and disconnect the plug from the electrical
socket.
6
The machine can only operate when the protec-
tive cover (10) is closed and the jug (7) is installed
properly on the motor unit (5).
• Clean the machine and the jug (7) before use
(See ==> Cleaning and Maintenance).
• Make sure the appliance is completely dry.
• Ensure that the electrical power supply corre-
sponds with the rating label on the machine.
CAUTION! Never bypass any safety micro switch.
• Always remove the jug set (7) when moving.
• Lift only at the bottom of the motor unit (4)
when moving.
• Place the whole jug set (7) onto the motor unit
(5) & close the protective cover (10).
• Connect the power plug to a suitable electrical
power supply socket.
• Switch ON the machine by pressing the pow-
er switch (1) to "I" position & select a suitable
speed by turning the speed dial (2).
Description
For mixing liquids
For mixing liquids and solid ingredients
For ice crushing or short, power impulse movements.
Note: Use the pulse function for 1 ~ 2 seconds each time. Repeated about
several times if necessary.