Setup 8: Adjust The Tilt And Height - Sony SDM-X75KB Bedienungsanleitung

If no picture appears on your screen
• Check that the power cord and the video signal cables are
properly connected.
• If "NO INPUT SIGNAL" appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
OK button (page 11).
• If "CABLE DISCONNECTED" appears on the screen:
– Check that the video signal cables are properly connected.
– Check that the input signal setting is correct by pressing the
OK button (page 11).
• If "OUT OF RANGE" appears on the screen:
Reconnect the old display. Then adjust the computer's graphics
board within the following ranges.
Analog RGB
28–80 kHz
Horizontal
frequency
48–75 Hz
Vertical
frequency
1280 × 1024 or less
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 19.
No need for specific drivers
The display complies with the "DDC" Plug & Play standard and
automatically detects all the display's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the
setup Wizard may appear on the screen. If this is the case, follow the on-
screen instructions. The Plug & Play display is automatically selected so
that you can use this display.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the display, you can use it as is. You do
not need to set the vertical frequency to any particular high value.
Digital RGB
28–64 kHz
60 Hz
11

Setup 8: Adjust the tilt and height

This display can be adjusted within the angles shown below.
Hold both sides of the LCD display, then adjust display
angles.
approx. 5°
approx.
175°
approx. 175°
When you use the height adjustable stand, the height adjust is also
available as below.
Hold both sides of the LCD display, and then adjust the
display height.
approx. 20°
GB
approx. 110 mm
11
(4 / inches)
32