Replacing The Battery - EINHELL 43.012.80 Bedienungsanleitung

Anleitung_RT_TC_560_U_SPK1:_
start up the machine.
7.3 ON/OFF switch (Fig. 11)
To switch on, press the "1" on the ON/OFF
switch (16).
Before you begin cutting, wait until the cutting
wheel has reached maximum speed and the
cooling water pump (13) has started supplying
the cutting wheel with water.
To switch off, press the "0" on the switch (16).
7.4 90° Cutting (Fig. 12-13)
Undo the two screws (30).
Loosen the star grip screw (29).
Set the angle stop (5) to 90° and retighten the
star grip screw (29).
Retighten the screws (30) to fasten the angle
stop (5).
Move the machine head (31) to the far end with
the handle (9).
Position the tile against the rail fence (6) on the
angle stop (5).
Switch on the tile cutting machine.
Caution: Always wait until the cooling water has
reached the cutting wheel (2) first.
Move the machine head (31) slowly and
smoothly forward through the tile with the handle
(9).
Switch off the tile cutting machine after
completion of cutting.
7.5 45° Diagonal cut (Fig. 14)
Set the angle stop (5) to 45°.
Cut as described in 7.4
7.6 45° Lengthwise cut, "jolly cut" (Fig. 15)
Loosen the star grip screw (10).
Tilt the guide rail (7) to the left to 45° on the
angle scale (32).
Retighten the star grip screw (10).
Cut as described in 7.4.
7.7 Changing the diamond cutting wheel
(Fig. 16-17)
Pull out the power plug.
Unscrew the four screws (33) and remove the
safety hood (8) for the blade.
Using the wrench (26), loosen the flange nut in
the direction of rotation of the cutting wheel (2).
(Caution: Left-hand screw thread). To do so,
place the wrench (25) on the motor shaft and
apply counter pressure.
Remove the outer flange (34) and cutting wheel
(2).
Clean the mounting flange thoroughly before
fitting the new cutting wheel.
30.12.2008 8:53 Uhr Seite 15
Fit the new cutting wheel by following the above
procedures in reverse and then tighten.
Caution: Pay attention to the direction of rotation
of the cutting wheel!
Mount the safety hood (8) for the blade again.
8. Operating the laser (Fig. 18-21)
8.1 Operation
To switch on: Move the ON/OFF switch (46) to the
"I" position.
To switch off: Move the ON/OFF switch (46) to the
"0" position.
Switch on the laser (45). A laser line is projected
onto the material you wish to process, providing an
exact guide for the cut. You can additionally adjust
the laser with the screw (47). To do so, undo the
screw (47) by a few turns and adjust the laser (45).
Tighten the screw (47) again when you are satisfied
with the adjustment.

8.2 Replacing the battery

Remove the base plate (49) as shown in Figure 20.
Take out the old batteries and replace with new
ones. Then fit the base plate (49) back on.
Dismantle the laser before you clean the machine
with water.
8.3 Dismantling
Undo the two Allen screws (48) to dismantle the
laser (45). To assemble, proceed in reverse order.
Please note that the laser must then be re-adjusted.
GB
15