10. Settings; User Settings; Basic Settings - Bosch WBE 4100 Originalbetriebsanleitung

10. Settings

10.1

User settings

i
Settings which can be made by the user.
1. Press and hold the <MENU> key.
2. As soon as appears in the left-hand display, release the <MENU> key.
5Et
"
appears in the left-hand display and the current value in the right-hand display.
toL
Function
Change of setting/value
Access to next setting, altered settings are stored
Exit from menu.
Attention: Altered setting is however stored
Setting
Tolerance for display value "0"
Display resolution
Balance weight
Unit for balance weight
Acoustic signal
Automatic start
Data arm selection
10.2

Basic settings

i
Basic settings which can only be made following consultation with or by customer service.
1. Press and hold the <MENU> key.
2. As soon as appears in the left-hand display, release the <MENU> key.
5Et
3. Press the <mm/inch> key within 1.5 seconds.
"
appears in the left-hand display and the current setting in the right-hand display.
P0t
Left Right Setting
display display
Switch-on and switch-off of
P0t on
electronic vernier caliper
oFF
Special rounding-off with higher display of
rnd on
weights in ounces
oFF
Robert Bosch GmbH
Left display Right display
Current value in
toL
grams / ounces
1 or 5
rE5
unb 6rA
oun
5nd on
oFF
CAr on
oFF
Mot on
oFF
Settings | WBE 4100 | 37
Key
<-> or <+>
<OK> or <MENU>
<STOP>
Description
Entry of balance weight value below which the value "0" is to
be displayed.
Standard value 4,5 g (0,25 oz), maximum value 25 g (0,25 oz)
5 g / 0.25 oz - Standard resolution
1 g / 0.05 oz - Fine resolution
6rA = Display in grams
oun = Display in ounces
on = An acoustic signal sounds on storing the data
determined
oFF = No acoustic signal sounds on storing the data
determined
on = Start of measurement by closing wheel guard
oFF = Start of measurement by pressing <START> key
(with wheel guard closed)
on = Use is made of standard data arm
oFF = Use is made of long data arm for balancing of
motorcycle wheels
Setting not possible, always select oFF
Description
oFF = Rim data must be entered manually
on = Electronic storage of rim data determined with vernier
caliper
Setting not possible, always select oFF
on = Special rounding-off of ounces
oFF = Standard rounding
en
|
1 695 656 133 2011-02-18