Filling And Venting The System; Relation Between Pump Settings And Performance - WITA go.tec 40 Serie Original Einbau- Und Betriebsanleitung

Translation of the original installation
and operating instructions

9 Filling and venting the system

The system must be filled and vented properly. To vent the pump, the electronics should be set to
constant speed level III and the pump should be operated in this position for at least 20 minutes.
Incomplete venting will result in increased noise during operation of the pump and
the system.
Warning! danger of burns!
Depending on the operating status of the system,
the entire pump can become very hot.
3
2
1

10 relation between pump settings and performance

The characteristics show the relation between pump settings and performance
H
3
2
46
WITA go.tec 40-XX
3
AUTO
1
Min
| 60-XX | 70-XX | 80-XX
2
1
2
1
3
Q