Electrical Connection; Maintenance And Service - WITA go.tec 40 Serie Original Einbau- Und Betriebsanleitung

WITA go.tec 40-XX

13 electrical connection

Connect the mains cable to the pump as shown in the figure.
Caution! Mains voltage! Always observe the necessary safety measures,
Vde regulations and local regulations.
The cross-section of the cable is 0.5 mm
PE N L
Caution! Danger to life!
Improper assembly and improper electrical connection can be life-threatening. Hazards due to
electrical energy must be excluded.
• Assembly and electrical connection may only be performed by qualified personnel
and in accordance with the applicable regulations (e.g. IEC, VDE, etc.)!
• The type of current and voltage must comply with specifications on the type plate.
• Observe the regulations of the local energy suppliers!
• Observe the accident prevention regulations!
• Never pull on the mains cable.
• Do not bend the cable.
• Do not place any objects on the cable.
• When using the pump in systems with temperature above 90°C,
an appropriately heat-resistant connection cable must be used.
• There is a danger of personal injuries due to sharp edges or burrs during
performing of assembly works.
• Never transport the pump by carrying it by the mains cable.
• There is a danger of personal injuries due to dropping the pump.

14 maintenance and service

Before carrying out maintenance, cleaning and repair works, disconnect
the system from the power supply and secure it against being switched on
again by unauthorized persons.
At high water temperatures and system pressures, wait for the pump to cool
down beforehand. There is a danger of burns!
| 60-XX | 70-XX
.
2
L
N
PE
| 80-XX
L: Brown
N: Blue
PE: Yellow-Green
GB
51