Changing The Coding; Technical Data - m-e ADV-1010 Bedienungsanleitung

ADV-1010 ENGLISH
ADV-1020

Changing the coding

If your radio chime receiver activates without
someone having rung the bell, an overlap
with another radio in the neighbourhood
could be the cause. In this case, you can
change the transmitted code of the outdoor
station as follows:
13. Press and hold the bell button* and the
button (17) simultaneously. After approx.
3 seconds the outdoor unit emits 3 tones,
continue to hold the buttons down. After
another 3 seconds, the outdoor unit
emits several tones. Now you can release
the buttons, the code has been changed.
GB
*With the ADV-1020, the code for both but-
tons can be set separately by pressing the
corresponding bell button here.
14. Reset the radio chime receiver to factory
settings to delete all learned transmit-
ters. The receiver must then be taught in
again. Refer to the operating instructions
for your receiver.

TECHNICAL DATA

Operating voltage: 15Volt DC
Current consumption: 270 ± 50mA
Frequency BELL: 434MHz; <10mW
Temperature range: -20°C to 50°C
Max. Humidity: 85%
Dimensions: 114x114x30mm (WxHxD)
32