Downlight; Advanced Functions; Tuning In The Radio Chime; Changing The Radio Chime Ring Tone - m-e ADV-1010 Bedienungsanleitung

gong receiver from the BELL or FG series can
be controlled.

Downlight

With the switch (16.6) the 3 downward shin-
ing LEDs can be switched off permanently. If
the switch is set to ON, the 3 LEDs are auto-
matically activated at dusk. If the switch is
set to OFF, the LEDs do not light up at all.

ADVANCED FUNCTIONS

Tuning in the radio chime

If the 434 MHz transmitter module is activ-
ated, any receiver from the BELL or FG series
can be controlled. Set the receiver to the
learning mode (see the receiver's operating
instructions) and then press the bell button
once on the outdoor unit to which the radio
chime is to respond. The receiver plays a
melody and is ready to be learned.
Please make sure that the receiver is not
muted.

Changing the radio chime ring tone

To change the ring tone, proceed as follows:
10. Press and hold the bell button* and the
button (17) simultaneously until the out-
door unit emits tones. Then release both
buttons.
*With the ADV-1020, the ring tone for both
buttons can be set separately by pressing the
corresponding ring button together with
button (17) here.
11. When the name plate flashes green, you
can press it and the receiver will play the
next ring tone. Wait until this has been
completely played by the receiver before
you select the next tone by pressing the
name plate. A total of 8 ring tones are
available
12. To save the ring tone, press the button
(17). The outdoor unit confirms the suc-
cessful storage with a long tone.
31
ENGLISH ADV-1010
ADV-1020
GB